Ultrasonic cleaning can be said to be a very advanced cleaning method, which is particularly suitable for today's highly developed society and can be used in various fields. However, because the ultrasonic cleaning machine itself is very accurate, the installation process should be performed in accordance with specifications, and all necessary work must be done patiently to make the equipment achieve the expected results. Specifically, the installation precautions of the ultrasonic cleaner include the following aspects.
First, focus on preparation and sandblasting
Before the ultrasonic cleaner is officially installed, prepare the ultrasonic transducer (with the correct one) and the glue to be glued one by one. At the same time, the manufacturer of the ultrasonic cleaning machine should stop the ultrasonic transducer and the required glue cylinder to stop sandblasting. The blasting joint must meet the requirements, and the blasting requirement is corundum. The requirements for sand are relatively high, such as careful selection and maintaining of drilling, etc .; the pressure of compacted air during sandblasting should be adjusted to the specified requirements, and the high-pressure air dehumidified by the air source processor.
Second, pay attention to related cleaning work
According to the manufacturers of ultrasonic cleaning equipment, the sand burning cylinder and the ultrasonic transducer should be cleaned first, and the latter should be cleaned with the prepared solution, and some dirt on the surface should be basically removed before cleaning. At the same time, please note that the cylinder of the ultrasonic cleaner needs to be cleaned multiple times in a row. After drying, take the special solution and stop once. The thickness of the mesh pad should meet the requirements, and the stainless steel mesh should be cleaned.
Third, pay attention to drying, pre-heat treatment
The cleaned ultrasonic transducer, cylinder block and mesh pad should be placed in an oven to stop drying. The drying temperature should also be controlled within the corresponding range. Then, after 2 hours of drying, it should stop when it cools to a certain temperature. After the ultrasonic cleaner company introduced all the glue preparation tasks, pay attention to the glue (normal temperature) and then stop the glue continuously.